how-sure · tool 04 · prospect volume as a range · v1.3

How much, and how sure?

A prospect's oil in place as a range, P90 to P10: where the range comes from, which inputs drive it, and which data could change the decision.

Maxim Balagurov, petroleum geologist. In my own work I ran probabilistic volumetrics (P90/P50/P10) using a Monte Carlo spreadsheet; this page shows the reasoning. Oil in place here is stock-tank oil initially in place (STOIIP). P90 is the low case, the volume exceeded with a 90 % chance, and P10 the high case. The example below is made up.

AThe low case is not every input at its low end

Chance of exceeding each volume The chance that the oil in place exceeds a volume, against that volume on a logarithmic scale, with P90, P50 and P10 marked, and the products of all inputs at their unfavourable and at their favourable ends.

Each input's low is a value it beats nine times in ten. All five landing at that end together is far rarer, so their product sits well below the P90. The same holds at the high end.

BA few inputs drive the range

What each input does to the volume, one at a time One bar per input: the volume with that input at its low and at its high value and the others at their P50, on a logarithmic scale, widest first.

The variance is that of the volume on a logarithmic scale, each input taken alone. Sharpening an input that accounts for a few per cent of it leaves the range almost as wide.

CWhich data could change the decision

Chance of reaching the minimum volume if one input were known One line per input: the chance that the volume exceeds the minimum if that input were known to sit at its low value and at its high value. A dashed line marks the required chance.

Each input is tested as if it could be known exactly. Real data only narrows a range, so this is the most that data on one input could do. Data can only be worth getting if its answer could move you across the line. Before the well, area is what seismic and depth conversion can sharpen; pay, porosity and saturation mostly wait for the well or rest on analogues. Tools 02 and 03 of this set ask the same of a survey and of a drilling campaign.

Try your own prospect

The form holds the made-up example: a prospect with seismic and nearby wells, so its ranges are fairly tight. An undrilled frontier prospect often has a P10 ten times its P90 or more. Change any number and the findings above and the numbers below update.

Inputs
InputLowHighDistribution

Low and high are the values the input exceeds with a 90 % and a 10 % chance. They describe the uncertainty in the average over the prospect, not the spread inside the reservoir. Lognormal suits positive, right-skewed quantities such as area and thickness; normal is adequate for average porosity, Sw and Bo while the range stays well inside 0 to 1. Set low equal to high to fix an input.

The decision
Correlated inputs

Better rock tends to hold less water. A deeper contact gives both a larger area and a thicker average pay.

If your ranges run narrow

If past predictions fell outside their ranges more often than they should, the ranges were too narrow. Tool 01 measures by how much.

The numbers in full

Limits

More limits
  • Oil in place only: no recovery factor, no gas, no column height tied to a spill point. Area times average net pay stands in for a mapped rock volume.
  • The minimum volume is set on oil in place to keep recovery out of the page. In practice it is set on recoverable oil.
  • Two distributions, lognormal and normal, both set by a low and a high value. A skewed fraction or a range with hard ends is not represented. Values below zero count as zero and Sw above 1 as 1; a widened normal range can still reach values that make no physical sense, such as Bo below 1.
  • Only two pairs of inputs can be correlated, each through one number. The bars and the variance shares in finding B take inputs one at a time and ignore correlation.
  • Finding C tests one input at a time, as if it could be known exactly. Two inputs known together are not tested.
  • The decision here is a volume and a chance. Cost, price and timing are left out on purpose.
How it works
  1. Oil in place = area × net pay × porosity × (1 − Sw) ÷ Bo, times 6.2898 to turn km²·m into million barrels.
  2. The page takes 50,000 sets of the five inputs. A fixed pattern, with no random numbers, spreads them evenly over all five ranges at once, so the tails are covered and the same inputs always give the same answer.
  3. The 50,000 volumes are sorted. P90 is the value 10 % of the way up, P50 the middle, P10 the value 90 % of the way up; the mean is their average, and the chance of the minimum volume is the share of volumes above it.
  4. "One at a time" varies one input from its low to its high value with the others at their P50. An input's share of the variance is its swing squared, on a logarithmic scale, over the sum for all inputs.
  5. "If it were known" holds one input at a value, takes the others again and reads the chance of the minimum volume. The value at which that chance equals the required one is found by halving the interval. If the input is correlated with a partner, the partner follows it.
  6. Correlated inputs share part of their position in the range: with a correlation of 0.5, a quarter of one input's variance is explained by the other.
  7. Widening multiplies each input's spread around its P50 and the page then works with the widened low and high values throughout.
Rules it uses
Checks:

The checks run in your browser each time the page opens, on fixed cases, whatever is in the form. "By hand" answers come from formulas and arithmetic written out beside them. "Independent calculation" answers come from volume_ref.py: plain Monte Carlo, 4,000,000 draws per case, sharing no code with this page.